The RealPro RS1 Series marine battery charger (formerly Recreation Series) is an affordable, reliable and safe battery charger for everyday use. The charger is engineered for users who need a charging system on an occasional basis and may not want or need the capabilities of a heavier duty and higher amperage product.
The Waterproof RealPro RS1 Series 6 amp charger is microprocessor controlled, powerful, and fast. If you need a quick and reliable battery charger for a 12-volt battery system, this is it. This industrial battery charger by Pro Charging Systems/Dual Pro incorporates important features such as being fully waterproof, completely automatic, overcharge protected, temperature compensating, and ignition protected. They also have LED readouts, and are USCG approved.
It is recommended for a 12-volt battery system no larger than a group 31 (approximately 130AH). The Pro Charging Systems RS1 is a rugged, waterproof construction charger requiring no mounting restrictions. Suitable with Flooded Wet Cell, AGM, or Lithium batteries!
Features
For Flooded, AGM, & Lithium!
Low 2-Volt Charge Detection!
Reverse polarity protected!
Ignition protected!
Designed for use in fresh and salt water
Dependable, rugged construction and waterproof
Battery maintenance mode
DC charge cables = 5ft
AC power cord = 3ft
Approved and meets ISO 8846 Marine standards
LED lights indicate the state of charge
FCC 15 Parts A and B Interference Compliant
2 Year Warranty
This Product Replaces These Other Products
DPXL6, IS1
Works In
Vehicles that RS1 works in
Technical Specifications
Dimensions (LxWxH): 3 x 4.5 x 6.5 in
Weight: 3 lb
Shipping Weight: 5 lb
DC Output Voltage: 12 V
Absorption Voltage: 14.7 V
AC Input Amps: 2 amps max
Maximum AC Current @ 90 VAC: 2 A
Maximum AC Current @ 180 VAC: less than 2 A
AC Input Volts: 100-240 VAC
AC Input Volts Freq.: 47-63 Hz
AC Input Volts Range: 90-264 VAC
Float Current: less than 500 mA
Float Voltage: 13.3 V
Power Requirements: 100 W
Maximum Power Output, Continuous: 72 W
Maximum Output Amps Single Surge: 6 amps(DC side)
Maximum Input Current: 2 amps
Equalization Voltage: none
Charge Reset: Battery Voltage Threshold: 2 volts for initalization of charge
Working Temperature: -30° to 65° C
Storage Temperature: 20° C optimum
Inline Fuse: 30 Amp AGX
Over Temperature: 100° C
Ripple and Noise: 250 MV max peak to peak
Enclosure: Blend Polycarbonate
Output Banks: 1
Temperature Compensation: Yes
Recommended Use: Harsh, outdoor, marine
Regulatory Approval: USCG 33 CFR183.410 CE Approved
Do you own the RS1? Please, tell us what you think about it. It helps us provide you with better products. Please note that it may take up to 72 hours for your review to appear.
★★★★★
Brian Y
I have used this make of charger for 3 years now. I especially like the durability of this charger.I just plug it in at night and in the morning when i head out the light tell me the battery is fully charged.I run a motor guide motor all day on one charge. I have an 18 FT Lund Boat.Still works great.
Cons:
Non
Is this review helpful?
Written byAnonymous on May 06, 2014.
Ownership: Use regularly.
— (87 of 163 customers found this review helpful)
★★★★★
Dual Pro 12v Charger
Good heavy duty charger for damp locations.
Super fast shipping, and great service.
Cons:
Haven't seen any yet.
Is this review helpful?
Written byAnonymous on Jun 05, 2014.
Ownership: Just Bought.
— (81 of 157 customers found this review helpful)
★★★★★
Thumbs Up
Was installed into a Ford F350 6.0L with dual batteries. Has been maintaining perfect voltage in both. Cold weather starts are easier and more powerful.
Sturdy construction, somewhat compact, wire leads length was good
Cons:
None this far
Is this review helpful?
Written byEric on Jan 08, 2015.
Ownership: Just Bought.
— (3 of 4 customers found this review helpful)
Write a ReviewDo you own the RS1? Please, tell us what you think about it.
It helps us provide you with better products. Please note that it may take up to 72 hours for your review to appear.
